These instructions help you configure your Cisco UCME / UC500 to work with TIM Enterprise. Contact your system maintainer if you are not familiar with the configuration of your PBX.
| Pbxsummary |
|---|
| Supportfiles1 | Cisco UCME - SysLog.TDT |
|---|
| Supportfiles2 | Cisco UCME - SysLog.TDS |
|---|
| Connection | SysLog connection |
|---|
| RequiredTask1 | Configure UCME to send SysLog events |
|---|
| RequiredTask2 | Configure Cisco AXL sync |
|---|
| RequiredTask3 | Configure TIM Plus to capture SysLog packets |
|---|
|
| HTML |
|---|
<a id="Configure UCME to send SysLog events"></a> |
Configuring UCME to send SysLog events
Use Telnet to connect to the IP address of your UCME as shown below:
Once connected, enter the following commands to enable the UCME to send SysLog events to TIM Plus: