These instructions help you configure your Cisco UCME / UC500 to work with TIM Plus. Contact your system maintainer if you are not familiar with the configuration of your PBX.

<a id="Configure Cisco AXL sync"></a>

Configuring Cisco AXL sync

Follow the steps below to configure TIM Plus to perform directory synchronisation with your Cisco UCME:

1. Click on the Directory tab.
2. Choose the site you want to configure and click Properties.
3. In the Site Properties window, select the Sync tab.
4. Tick the option entitled Synchronise with the following device .
   
5. In the Host field, enter the IP address of your UCME.
6. In the  field, enter the port number of the IOS service, e.g.  .
7. In the Username field, enter the username of the IOS login that can perform synchronisation.
8. Click on the Set button and enter the password of the IOS login that can perform synchronisation.
9. Click on the Save button to apply the changes.

<a id="Configure UCME to send RADIUS events"></a>

Configuring UCME to send RADIUS events

Use Telnet to connect to the IP address of your UCME as shown below:

Once connected, enter the following commands to enable the UCME to send RADIUS events to TIM Plus:

Step	IOS commands	Description
1	enable	Causes the UCME to enter EXEC mode. Type your EXEC password if requested
2	conf t	Enters the global configuration mode
3	aaa new-model	Enables aaa accounting mode
	aaa accounting connection h323 start-stop group RADIUS
	gw-accounting aaa
	acct-template callhistory-detail
4	RADIUS-server host 192.168.0.1 auth-port 0 acct-port 1612	Specifies the IP address and port of TIM Plus's RADIUS, to which CDR data will be sent, e.g.
5	RADIUS-server key C1sco	Specifies a RADIUS authentication secret that will be used by TIM Plus (configured in the next section), e.g.
6	RADIUS-server vsa send accounting	Enables VSA events
7	end	Exits configuration mode
8	wr	Saves the changes

<a id="Configure TIM Plus to capture RADIUS packets"></a>

Configuring TIM Plus to capture RADIUS packets

Follow the steps below to configure TIM Plus to receive RADIUS data from your UCME:

1. Click on the Directory tab.
2. Choose the site you want to configure and click Properties.
   
3. In the Site Properties window, select Cisco UCME - RADIUS from the PBX model drop-down list.
4. In the Connection method field, select RADIUS connection from the drop-down list.

5. In the Client IP field, enter the IP address of your UCME.

6. In the Secret field, enter the RADIUS-server key you configured on your UCME in the section above, e.g. C1sco.

7. Click on the Save button to apply the settings.