Avaya Meridian Option Series

These instructions should assist in configuring your Aastra BP to work with TIM Enterprise. If you are not familiar with PBX configuration, please contact your system maintainer.

Configuring your CDR

By default, the Avaya Meridian Option CDR output is disabled. You will need to speak to your system maintainer to have this enabled. They will need to enable CDR output for incoming, outgoing and internal calls. In addition to this for incoming calls they will need to enable CLI information, DNIS information, response time information and abandoned calls.

You will need to configure one of the 'TTY' ports on the Avaya Meridian Option Series to output CDR information. You will then need to connect the serial cable from the 'TTY' port to the PC that NetPBX is installed and running on.

The sections below document where to go to. Required entries are highlighted.

1. Enable CDR (command: LD 21)

2. Port Setup (command: LD 22)

3. CDR Format (commands: LD 22; LD 17)

NOTE: CDR output port values, from above: Baud = 1200; data bits = 8; parity = None; stop bits = 1; flow control = DTR/RTS Use CDR format #511 (Meridian / SL1-X11) or #526 (CS 1000 Rel 4+ / Meridian 1).

Configuring TIM Enterprise

Below you will find steps on how to configure TIM Enterprise to listen for SMDR data from your Avaya Meridian M2250:

1. Browse to TIM Enterprise as normal and login with your credentials.
2. Click on the Directory tab.
3. Go the the point in the Directory where you need to add the PBX Object and add a PBX with the name 'Avaya Meridian M2250'.
4. Left-click on it and select Properties.
5. From the General settings tab select Avaya Meridian Option Series from the PBX model list.

6. In the Connection tab select No connection required from the Connection method list.
7. Finally, click on the Save button.